Filter
Top Products
15
Dimensions in parentheses are in
millimeters unless otherwise specified.
MODELS 427 AND 427R INSTALLATION
POSITION THE UNIT
I
MPORTANT NOTE:
F
or Model 427R, the top
drawer has a control cable that needs to be
disconnected before removing this drawer.
Refer to illustration 3 below for placement and
how to disconnect this fitting.
For Model 427R, the drawers should be placed
aside until you are ready for installation of the
door and drawer panels.
IMPORTANT NOTE:
When two Model 427,
427R or Integrated units are installed closer
than 2" (51) to one another, it is necessary
to use the Sub-Zero dual installation heater
kit. Contact your Sub-Zero dealer or call
800-222-7820 for the proper components and
additional instructions. The heater plate from
this dual installation heater kit must be
attached to the left side exterior of the right
hand unit before the unit is slid into position.
Illus. 3
Always wear safety glasses and use other
necessary protective devices or apparel
when installing or working with anchors.
Anchors are not recommended for use in
lightweight masonry material such as
block or brick, or for use in new concrete
which has not had sufficient time to cure.
The use of core drills is not recommended
to drill holes for the anchors.
Installation for Concrete Wedge Anchors:
1)
Drill a
3
/8" (10) diameter hole any depth
exceeding the minimum embedment. Clean
t
he hole or continue drilling additional
depth to accommodate drill fines. Use a
carbide drill bit manufactured within ANSI
B
94.12-77.
2)
Assemble the washer and nut flush with the
end of anchor to protect threads. Drive the
anchor through the material to be fastened
until the washer is flush with the surface
material.
3)
Expand the anchor by tightening the nut
3–5 turns past hand-tight position or to 25
foot-pounds of torque.
Before moving the Wine Storage unit into
position, secure the door closed. Remove
the drawers of the Model 427R.
MODELS
427 | 427R
OPTIONAL
COMPONENTS
Optional installa-
tion components
are available
through your
Sub-Zero dealer,
or call Sub-Zero at
800-222-7820.
You can also visit
our website at
subzero.com.