Sub-Zero 430/F Beverage Dispenser User Manual


 
MODELS 424 AND 424FS
SITE PREPARATION
T
he Sub-Zero Model 424FS wine storage unit
is designed to be attractive in a stand alone
setting. It can also be slid into surrounding
c
abinetry with clearance dimensions slightly
different than the standard built-in Model 424.
Make sure that the finished rough opening
where the Wine Storage unit is to be installed
is properly prepared. Refer to the Installation
Specifications illustration for rough opening
dimensions, door swing clearance and electri-
cal placement for Models 424 and 424FS.
IMPORTANT NOTE:
To operate properly, the
door must open a minimum of 90 degrees.
Use a minimum 3" (76) filler in corner installa-
tions to assure a 90-degree door opening.
Allow enough clearance in front of the unit for
full door swing.
IMPORTANT NOTE:
Make sure the floor under
the unit is level with the surrounding finished
floor.
3
Dimensions in parentheses are in
millimeters unless otherwise specified.
MODELS 424 AND 424FS INSTALLATION
34
1
/2"
(
876)
R
OUGH
O
PENING
HEIGHT
34
1
/4"
(870)
MINIMUM
HEIGHT
R
EQUIRED
ROUGH OPENING
W
IDTH
24"(
610) MODEL 424
24
3
/8"(619) MODEL 424FS
15
1
/2"
(394)
24"
(
610)
R
OUGH
OPENING
D
EPTH
L
OCATE ELECTRICAL
WITHIN SHADED AREA
E
4
1
/2"
(
114
)
2
1
/2"
(64)
23
7
/8"
(606)
M
ODEL 424
ANTI-TIP BRACKET
M
ODEL 424FS
ANTI-TIP BRACKET
90˚
145˚
MAXIMUM
DOOR SWING
44" (1118)
DOOR CLEARANCE
26" (660)
DOOR CLEARANCE
25
3
/8"
(644)
25
3
/8"
(645)
FRONT VIEW
TOP VIEW
Do not load wine into the Wine Storage
unit until the installation is complete.
INSTALLATION SPECIFICATIONS
NOTE: Door swing clearances are based on stainless
steel door and handle dimensions.
MODELS
424 | 424FS