Filter
Top Products
Convection Steam Oven Installation 12
Install the Oven
WITHOUT TRIM
IMPORTANT NOTE:
Before moving the oven, protect any
finished flooring and cabinetry to avoid damage.
1) Move the convection steam oven into position near
the installation opening. Remove and discard packing
materials.
2) Carefully place the oven in the opening. Resting the
oven on the cabinet base support, slide the unit into
the opening until it is approximately 6"
(152) from being
fully installed. Guide the power cord through the
opening of the adjacent cabinet or base support as the
oven is slid into position. Verify the power cord is not
trapped between the oven and cabinet wall.
3) Once the oven is fully positioned in the opening, open
the oven door and locate the four mounting holes on
the oven side trim. Refer to the illustration below. Use
a
1
/16" drill bit to drill pilot holes into the cabinet.
4) Using the mounting screws provided, secure the oven
to the cabinet.
IMPORTANT NOTE: T
o avoid interference, a 90° door stop
may be required for any appliance or cabinet door installed
next to the convection steam oven.
Failure to install the mounting screws may cause the
oven to tip forward during use.
T
E
M
P
M
O
D
E
L
I
G
H
T
W
A
T
E
R
T
I
M
E
O
F
F
P
O
W
E
R
O
N
OVEN MOUNTING HOLES
Oven installation without trim.