Filter
Top Products
COMBINATION INSTALLATIONS
The Wolf convection steam oven with trim is designed
and agency approved for installation with Wolf cooktops,
built-in ovens, microwaves and warming drawers only.
If it is being installed above or below an E series oven in a
flush inset application, a
1
/4" (6) reveal is required.
For typical combination installations, refer to the illustra-
tions on pages 9–11.
Convection Steam Oven Specifications 5
wolfappliance.com/specs
Convection Steam Oven
T
he convection steam oven can be installed with or
without side trim in a standard or flush inset application.
The installation opening must have a flat, level base to
support the oven. A minimum base support of 100 lbs
(45 kg) is required. The electrical supply for the oven must
be located in an adjacent cabinet.
STANDARD INSTALLATION
For standard installations, the convection steam oven is
installed by inserting into cabinetry from the front. The
oven has face trim on the top and both sides that will
overlap stiles and rails. Refer to the chart below for trim
overlaps.
FLUSH INSET INSTALLATION
For flush inset installations, a minimum
1
/8" (3) reveal is
required on all four sides. The inside edges of the rough
opening must be finished, as they will be exposed when
the oven door is open. These edges should be stained
instead of having a laminated surface, to avoid damage
from high temperatures and steam.
Oven Trim Overlap
Top Overlap
3
/16" (5)
Bottom Overlap 0" (0)
Side Overlap (without trim)
5
/8" (16)
Side Overlap (with trim) 3
13
/16" (97)