Filter
Top Products
MODELS ICB424 AND ICB424FS
SITE PREPARATION
The Sub-Zero Model ICB424FS wine storage
unit is designed to be attractive in a stand
alone setting. It can also be slid into surround-
ing cabinetry with clearance dimensions
slightly different than the standard built-in
Model ICB424.
Make sure that the finished rough opening
where the Wine Storage unit is to be installed
is properly prepared. Refer to the Installation
Specifications illustration for rough opening
dimensions, door swing clearance and electri-
cal placement for Models ICB424 and
ICB424FS.
IMPORTANT NOTE:
To operate properly,
the door must open a minimum of 90 degrees.
Use a minimum 76 mm filler in corner installa-
tions to assure a 90-degree door opening.
Allow enough clearance in front of the unit
for full door swing.
IMPORTANT NOTE:
Make sure the floor under
the unit is level with the surrounding finished
floor.
3
MODELS ICB424 AND ICB424FS INSTALLATION
Do not load wine into the Wine Storage
unit until the installation is complete.
INSTALLATION SPECIFICATIONS
NOTE: Door swing clearances are based on stainless
steel door and handle dimensions.
MODELS
ICB424
ICB424FS
876 mm
ROUGH
OPENING
HEIGHT
870 mm
MINIMUM
HEIGHT
REQUIRED
ROUGH OPENING
WIDTH
610 mm MODEL ICB424
619 mm MODEL ICB424FS
394 mm
610 mm
ROUGH
OPENING
DEPTH
LOCATE ELECTRICAL
WITHIN SHADED AREA
E
114
mm
64 mm
606 mm
MODEL ICB424
ANTI-TIP BRACKET
MODEL ICB424FS
ANTI-TIP BRACKET
90˚
145˚
MAXIMUM
DOOR SWING
1118 mm
DOOR CLEARANCE
660 mm
DOOR CLEARANCE
644 mm 645 mm
FRONT VIEW
TOP VIEW