Sub-Zero ICB430 Beverage Dispenser User Manual


 
Installation for Concrete Wedge Anchors:
1)
Drill a 10 mm diameter hole any depth
exceeding the minimum embedment.
Clean the hole or continue drilling addi-
tional depth to accommodate drill fines.
Use a carbide drill bit.
2)
Assemble the washer and nut flush with the
end of anchor to protect threads. Drive the
anchor through the material to be fastened
until the washer is flush with the surface
material.
3)
Expand the anchor by tightening the nut
3–5 turns past hand-tight position or to
34 newtons of torque.
6
MODELS ICB424 AND ICB424FS INSTALLATION
ANTI-TIP BRACKET
INSTALLATION
WOOD FLOOR APPLICATIONS
Use the four #12 x 64 mm wood screws and
the four 6 mm flat washers provided. Drill pilot
holes 5 mm diameter maximum, and be sure
that the screws penetrate through the flooring
material and into the wall plate a minimum of
19 mm. Be sure that the screws hold tight.
Refer to illustration 4 below.
CONCRETE FLOOR APPLICATIONS
Use the two 10 mm x 95 mm concrete wedge
anchors, two #12 x 64 mm wood screws and
two 6 mm flat washers provided. Be sure that
the anchors and screws hold tight. Refer to
illustration 5 below.
IMPORTANT NOTE:
In some installations
the subflooring or finished floor may require
angling the wood screws used to fasten the
anti-tip bracket to the back wall. Refer to
illustrations 4 and 5.
310
mm
310
mm
610
mm
C
L
WOOD FLOOR
Finished Flooring
Underlayment
Sub Flooring
Wall Plate
610
mm
C
L
CONCRETE
FLOOR
Finished Flooring
Underlayment
Sub Flooring
Wall Plate
38
mm
min
310
mm
310
mm
Illus. 4 Illus. 5
Make sure that there are no electrical
wires in the area which the screws could
penetrate.
Always wear safety glasses and use other
necessary protective devices or apparel
when installing or working with anchors.
Anchors are not recommended for use in
lightweight masonry material such as
block or brick, or for use in new concrete
which has not had sufficient time to cure.
The use of core drills is not recommended
to drill holes for the anchors.
MODELS
ICB424
ICB424FS