Filter
Top Products
99
IMPORTANT NOTE: There is a part, packed with the ice
maker, that is required for this procedure.
1) Remove the hinge cover.
2) Remove the door by removing the (4) screws that
secure the door to the door hinges.
3) Remove the door hinges by removing the (4) screws
that secure them to the cabinet.
4) Remove the (4) screws from the opposite hinge side
(or left-hand hinge mount holes) and reposition into
the right-hand hinge mount holes.
5) Install the hinges using the left-hand cabinet mount
holes.
6) Install the door using the left-hand door mount holes.
7) Remove the (2) screws which secure the upper door
panel mount bracket.
8) Install the upper door panel mount bracket using the
left-hand mount holes.
9) Install the left-hand door hinge cover with the origi-
nal screws.
10) Check the operation of the door by opening and clos-
ing it.
INSTALLATION
Panel Considerations
Refer to instructions for installation under "Panel
Installations".You should be sure of panel sizes and place-
ment before proceeding with installation. If you have
questions, contact the selling Sub-Zero dealer or cabinet
supplier. Instructions regarding sizing of the panels are
provided in the "Sub-Zero Design Guide".
IMPORTANT NOTE: Do not install hinge covers until the
door swing direction and door stop angle have been final-
ized.
Side Panels
With Model 315 you must securely fasten the side panels
to adjacent cabinets and floor.
Panels should be fastened to the floor and walls using "L"
brackets (hardware not provided). To help you move the
unit into place, route out an area in the floor so the ‘L’
bracket will sit flush with the floor level. Brackets and
screws are provided for mounting the unit to adjoining
cabinets and side panels.
Reversing Door Swing
The hinged side of the door may be reversed to the other
side if desired.
The Model 315 was shipped with the door hinged at the
right. The door and hinges are designed for placing the
hinges on either the right or the left side of the cabinet.
Moving the hinges to the left in the pre-drilled holes,
allows the door to pivot from the left side.
Right-Hand Door Swing
Configuration
Left-Hand Door Swing
Configuration