Filter
Top Products
Ice Machine Installation 12
Panel Installation
DOOR PANEL INSTALLATION
You should be sure of the door panel size and placement
before proceeding with the installation. Refer to the chart
for panel specifications. If you have questions, contact
your authorized Sub-Zero dealer or cabinet supplier.
For door handle hardware, a D-style pull, centered on the
edge opposite the door hinge side is recommended.
Screw heads may need to be countersunk to ensure that
the hardware does not interfere with the panel fitting flush
with the door.
Remove the handle side bracket attached to the front of
the door and set aside. Place the door panel lying face
down on a protected surface to ensure that the front will
not be scratched or damaged.
On the back of the panel, position the plastic template
(provided) flush with the top and side edges. Be sure you
are following the exact position for right-hand or left-hand
door swing. Refer to the illustration below.
Panel dimensions in the chart are the minimum necessary
to cover the door. The exact dimensions of your door
panel may vary depending on your particular installation.
Once you have located the proper position for the
hardware, mark the holes, remove template, and drill
pilot holes for mounting the hardware. It is best to start the
first few holes, position the hardware and then drill the
remaining pilot holes. Secure the mounting brackets with
#8 x
1
/2" screws. Refer to the illustrations below.
Install the door panel by engaging the tabbed bracket to
the door first and then sliding the hinge side hardware
over the positioning screws. You will have a
1
/4" (6) adjust-
ment, up and down, and side to side.
Once you have the door in place, attach the remaining
#8 x
1
/2" screws to the hinge side mounting bracket and
install the hinge covers. Refer to page 14.
Right-hand door panel. Left-hand door panel.
Door Panel Specifications
Panel Width 15" (381)
Panel Height 30
3
/8" (772)
Minimum Thickness
5
/8" (16)
Maximum Weight 15 lbs (
7 kg)
Dimensions based on
1
/8"
(
3)
reveal.
Template position.