Filter
Top Products
Installation
90° DOOR STOP
Door stop pins provided with the ice machine will limit the
door swing to 90°. Follow these steps to install:
1) Open the door to approximately 80°.
2) Insert the stop pin into the bottom door hinge (pin
enters from the top). Refer to the illustration below. The
pin must be inserted until the head has made contact
with the hinge body.
3) Insert the stop pin into the top door hinge (pin enters
from the bottom).
4) Check for proper operation.
HINGE COVER INSTALLATION
Install the hinge covers after installation of the ice machine
is complete. The 90° door stop must be installed prior to
installing the hinge covers. It will be necessary to remove
the knock-out in the hinge cover when the 90° door stop
is used.
Make sure hinges are free of dirt or grease before applying
covers. To install, remove backing paper from the adhesive
pads and bond to the hinge. Attach the magnetic center
covers. Refer to the illustration below.
Ice Machine Installation 14
DOOR STOP PIN
90° door stop. Hinge cover installation.
KNOCK-OUT
Installation Checklist
T
o ensure a safe and proper installation, the following
checklist should be completed by the installer to ensure
that no part of the installation has been overlooked.
INSTALLATION CHECKLIST
Have all electrical and water connections been made?
Is the power cord plugged into a properly grounded
3-prong outlet, which has been installed in accordance
with all applicable electrical codes?
Is the water supply turned on? Have water supply and
drain connections been examined for leaks?
Is the ice machine drain line routed to an open site
drain for gravity drains and according to instructions
for drain pump models?
Has all packing materials and tape been removed?
Is the ice machine level? Are all leveling legs making
contact with the floor?
Has the kickplate been installed properly? Is there
proper clearance in front of the kickplate for airflow?
If applicable, is the door panel installed properly?
If applicable, has the 90° door stop been installed?
Have hinge covers been installed?
Has the ice machine and bin been sanitized?
Does the customer understand the unit's operation and
maintenance? Have you given the customer the
warranty package?
Have any installation or service problems been noted
on the product registration card? Has the registration
card been mailed in?
If applicable, has the stainless steel door panel been
inspected for any imperfections? This is to be done by
the dealer or installer with the customer upon comple-
tion of the installation. Stainless steel panels are
covered by a limited 60-day parts and labor warranty
for cosmetic defects.