Sunbeam 2360 Mixer User Manual


 
9
NOTE: Replacement bulbs may be
purchased from local hardware or
department stores or from your
nearest authorized Sunbeam Service
Center (6 watt maximum bulb
can be used.)
To replace the worklight lens,
repeat the steps described in
“To remove the worklight lens”
in reverse order.
S
TORING
Y
OUR
M
IXER
Store the mixer in a dry location,
such as on a counter top or table top,
or in a closet or cupboard.
Place the small mixing bowl inside
the large mixing bowl with the beaters
inserted into the proper sockets.
Place the dough hooks in the
small mixing bowl. Store the bowls
on the turntable. The beaters will help
hold the bowls in position. Wind the
electric cord into a coil, secure it
with a twist fastener.
M
AINTENANCE
The motor of your stand mixer has
been carefully lubricated at the
factory and does not require
any additional lubricant.
Other than the recommended
cleaning and worklight replacement,
no further user maintenance
should be necessary.
Return the mixer to the nearest
Sunbeam Service Center for
servicing or repairs.
MIXING AND BAKING SUGGESTIONS
• Ingredients should be added to the
mixing bowl as they are specified in
the recipe. When combining dry
and wet ingredients, you may wish
to moisten ingredients on Speed 1
or 2, then turn to the desired
mixing speed.
Use the mixing speed that is
recommended in the recipe. When
using a recipe that is not in this book,
use the handy mixing guide on the
Mix-Finder
®
dial of the mixer to help
you find the correct speed to use.
If times are specified in the recipe,
use them! BE CAREFUL NOT TO
OVERMIX. Overmixing can cause a
mixture to become very tough.
Should an object, such as a spatula,
fall into the bowl while the mixer is
operating, turn the mixer off
immediately. Then, remove the object.
Remove beaters and place in sink
for easy clean-up.
When preparing your favorite
recipe, DO NOT exceed 3-1/2 cups
of flour grain in a recipe.