Filter
Top Products
4
OPERATION OF YOUR KETTLE
PRIOR TO FIRST USE
It is recommended that you clean your new kettle thoroughly before using it for the first
time. To do this, fill the kettle with fresh water and boil. Discard the water and repeat.
Rinse the kettle with cold water. Follow the instructions as stated below.
1. Fill with the desired amount of water.
Note: Do not fill with less than the minimum level as indicated on the Kettle,
or more than the maximum level as the water may spill over when boiling.
2. Plug cord into a power outlet.
3. Press the ON/OFF Switch downward, located at the back of the Kettle.
The water will start heating and the Kettle will switch off automatically once the water
has boiled.
Note: Ensure that the ON/OFF switch is clear of obstructions. The Kettle will not turn off
if the ON/OFF switch is constrained. To detach the cord, remove plug from
wall outlet then from appliance.
4. To re-boil, repeat steps 1-3.
Note: Ensure the power is turned off when the kettle is not in use.
Should you accidentally allow the Kettle to operate without water, the boil dry mechanism
will operate. If this should occur, allow the Kettle to cool before filling with cold water
and re-boiling.
CARE AND CLEANING
Mineral deposits in tap water may cause the water gauge and the inside of the Kettle
to discolor after frequent use. To remove this build-up, fill the Kettle with 3 cups of
white vinegar and the remainder with water and allow to stand overnight.
Empty the solution from the Kettle. Any stain remaining just inside the spout area
can be removed by rubbing with a damp cloth.
Fill the Kettle with clean water and bring to boil. Repeat and the Kettle will be ready to use.
Always disconnect the appliance from the power point before cleaning. Never immerse
the Kettle in water or other liquids.
The outside of the Kettle can be wiped over with a damp cloth.
CAUTION: Never use any chemical, steel wool, or abrasive cleaners to clean the outside
of the Kettle.