Filter
Top Products
14
Before using your Sunbeam Café Crema
®
II
for the first time or if you have not used it
for some time, rinse the machine by running
water through without coffee in the group
handle, as follows:
Note: Throughout these instructions the
numbers you see highlighted and in brackets
refer back to the diagrams at the start of this
instruction manual.
• Open the lid of the water reservoir (1) and
fill with cold water (2). Alternatively you
can open the lid and remove the water
reservoir using both hands (3). Then fill
with cold water (4).
• Replace the water reservoir firmly into the
unit (5) and close lid.
• Insert the power plug into a 230-240V AC
power outlet and turn the power (
) on.
Start the unit (6). The red power (
) light
will illuminate and flash to indicate it is
warming up.
• Place one of the filters in the group handle
(7). Then position the group handle on the
machines brewing head (8).
• To ensure that the group handle is in
the correct position, turn the handle so
it points to the left and place the group
handle flat against the brewing head (8),
then turn the handle towards the right (9),
as far as it can go.
Note: Do not over tighten.
• Place a sufficiently large container under
the group handle pouring spouts (10).
• When the power button has stopped
flashing and is completely illuminated, the
machine is ready for the next step.
• Turn the dial to the espresso (
) setting
(11) and allow all the water in the water
reservoir to run through.
• If necessary, you may need to stop the
operation by turning the dial to the off
( ) position, empty the container, then
resume the operation.
Note: Make sure that the water reservoir is
clean and free of any debris, as any fine
particles can block the water flow.
Before using your Café Crema
®
II