Filter
Top Products
Heading
5
Using your EasyClean Banquet
Before the first use: Wash, rinse and dry your
frypan and lid. Season the cooking surface by
applying a thin coat of cooking oil and rub in
with paper towelling.
1. Insert the control probe into the inlet on
the frypan.
2. Plug the cord into a 230-240V power
outlet and turn the power on.
3. Preheat the frypan on setting 7-8. Then
set the control probe dial to the desired
temperature setting. Refer to page 4 for
the temperature guide.
Note: The light on the control probe will
illuminate and will remain on until the
set temperature is reached. It will then
cycle on and off throughout cooking, as
the temperature is maintained by the
thermostat. On initial heating of the frypan,
it is recommended that the temperature be
allowed to cycle (the light cycling on and
off) several times. This will help the cooking
surface to adjust to a more accurate cooking
temperature.
Note: Any discolouration on the cooking
surface that may occur will not affect the
cooking performance. Do not use metal
utensils, these will scratch and damage
the non-stick cooking surface. Sunbeam
recommends only using heat-proof plastic or
wooden utensils to stir food.
Using the pan tilt lever
The pan tilt lever is positioned under the inlet
where the Control Probe is inserted.
To tilt the frypan, push the lever down. This
allows the fat and juices to drain from the
food for crisp, low fat cooking. It also makes it
easier to baste food and serve sauces or gravy.
Pan tilt lever