Filter
Top Products
10
1. Remove the cartridge from its wrapping (it
is normal for the cartridge to appear moist
during storage).
2. Immerse the cartridge in cold water and
agitate gently to remove any air bubbles.
See figure 1.
Note: There is no need to presoak this
cartridge before use.
3. Insert the cartridge into the filter funnel
assembly and push it firmly into place.
When correctly fitted, the cartridge should
remain in place when the funnel is turned
upside-down. See figure 2.
4. Fill the filter funnel with cold water and
allow it to filter through, and then discard
the water. Repeat this process, again
discarding the water. See figure 3.
5. Refill the filter funnel with water, the filter
is now ready for use. See figure 3.
Note: You do not need to keep the filter
cartridge immersed in water.
Removing the filter cartridge
• When it is time to replace the cartridge
after 8 weeks use, simply lift the handle on
top of the cartridge to remove. See figure
4. The cartridge may be disposed of in
household waste or contact the BRITA Care
Team for advice on recycling schemes.
• Always ensure that you have spare
cartridges available.
• Repeat steps 1-5 with a new cartridge.
Figure 3
Figure 4
Preparing the filter cartridge for use
Figure 1
Figure 2