Filter
Top Products
8
Using your BRITA Kettle
Before using your kettle
• Remove any packaging or promotional
material from the kettle.
• Remove the filter cartridge from the filter
assembly and keep in a safe place.
• Remove the filter assembly, wash in warm,
soapy water, rinse and wipe dry.
• Position the kettle on a dry, level, secure
bench top.
Using your kettle
Important: Prior to using your kettle see
sections ‘Preparing the filter cartridge for
use’ and ‘Using the Memo function’.
1. To fill the kettle, remove it from the power
base and lift the lid, by pressing the button
on the top of the handle.
Note: Do not fill the kettle through the spout.
2. Fill the kettle with the desired amount of
water. Always fill the kettle between the
minimum and maximum marks. Too little
water will result in the kettle switching off
before the water has boiled.
Note: Do not fill the kettle over the maximum
level, as water may spill out of the spout
when boiling. When using the kettle with the
BRITA filter the maximum capacity is 1.25
litres.
With the BRITA filter and filter funnel
removed the maximum capacity is 1.7 litres.
3. Push the lid closed firmly until it locks into
position.
4. Place the kettle on the power base and
connect the plug into a 230/240 Volt AC
power outlet. Turn the power ON.
Important: The kettle is designed to boil and
filter water at the same time, however some
water does need to filter through to avoid the
kettle boiling dry. Therefore if the kettle is
empty prior to filling, before switching the
kettle on wait a moment after adding the
water to allow some water to pass through
the filter first.
5. Press the ON/OFF switch. The internal
water chamber illuminates and this is
visible through the water windows. The
kettle will switch off automatically once the
water has boiled.
Note: Ensure that the ON/OFF switch is clear
of obstructions and the lid is firmly closed.
The kettle will not turn off if the ON/OFF
switch is constrained or if the lid is left open.
Do not remove the kettle from the power base
while in use.
6. Lift the kettle from the power base and
pour the water.
Note: Use caution when pouring the water
from your kettle, as boiling water will scald.
7. The kettle may be stored on the power
base while not in use. The kettle will not
re-boil until the ON/OFF switch is pressed
downward.
Note: Ensure the power is turned off at the
power outlet when the kettle is not in use.