Filter
Top Products
9
Care and cleaning Instructions
Always disconnect the Stainless Drip Filter
from the power outlet before cleaning any
parts.
Do not immerse the power cord, plug or unit
in water or any other liquid.
After each use
1. Clean all detachable parts including the
filter basket holder, mesh filter basket,
glass carafe and plastic spoon in warm,
soapy water.
2. Wipe the exterior of the appliance with
a soft, damp cloth to remove any stains.
Never use any abrasive agents on the
appliance.
3. Water droplets may build up in the area
above the funnel and drip onto the product
base during brewing. To control the
dripping, wipe off the area with a clean,
dry cloth after each use of the product.
4. Use a damp cloth to gently wipe the keep
warm plate. Never use any abrasive agents
on the keep warm plate.
5. Replace all parts into position ready for
next use.
Removal of mineral deposits
Over time, mineral deposits in tap water may
build up in the water tank and internal tubes.
It is important to periodically remove these
mineral deposits to ensure the optimum
performance of your appliance.
To remove this build-up, use Sunbeam Liquid
Descaler, a simple to use, non-toxic cleaner
available from Sunbeam Appointed Service
Agents.
Alternatively:
1. Place the Stainless Drip Filter on a flat,
level surface.
2. Fill the water tank to the maximum
capacity with 2/3 water and 1/3 white
vinegar. Close the tank lid.
3. Press the ON/AUTO/OFF button once, and
the solution will start to drip through into
the carafe. Once one cup of water has
dripped through into the carafe, press
the ON/AUTO/OFF button twice to turn the
appliance off.
4. Leave the appliance off for 15minutes
to allow the solution to take effect in the
internal tubes and water tank.
5. After 15 minutes, press the ON/AUTO/OFF
button once, and wait for the rest of the
solution to drip through into the carafe
until the water tank is empty.
5. Remove the carafe, filter basket holder and
removable mesh filter and clean in warm
soapy water. Rinse and dry thoroughly and
position back into place in the appliance.
6. Fill the water tank to the maximum
capacity (12 cups) and press the ON/
AUTO/OFF button once, and allow water to
drip into the carafe until the water tank is
empty. Empty the carafe and repeat 2 more
times.
Your appliance has now completed the
removal of mineral deposits and is ready
for use.