Sunbeam 2356 Mixer User Manual


 
4
A
SSEMBLING THE
S
TAND
M
IXER
Before assembling the mixer, be
sure the Mix-Finder
®
dial is in the
ZERO position and the electric cord
is unplugged.
A
TTACHING THE
T
URNTABLE
Place the revolving turntable into
the base of the stand using the socket
corresponding to the size of the bowl.
A
TTACHING THE
M
IXER
H
EAD
Press in on the mixer-release trigger,
located at the rear of the stand.
For models equipped with a head lock
feature – While pressing in on the
mixer-release trigger, press in on the
head-lock latch. This is best
accomplished by using the thumb and
forefinger of the same hand and
pressing inward.
This will open the top of the stand to
receive the mixer head. Place the mixer
head on the top of the stand so that the
metal pivot, located on the bottom of
the mixer head, goes into the open
groove on the top of the stand.
As you release the mixer-release trigger,
the top of the top of the trigger should
clamp around the metal pivot.
For models equipped with a head-lock
feature–To lower the mixer-head for
normal operation, support the mixer
head with one hand. Then press in on
the head-lock latch. Gently lower the
mixer head until the mixer head is in a
normal operating position.
Be sure the mixer head is securely
attached to the stand before using.
NOTE: This mixer is NOT intended
for use away from the stand.
A
DDING THE
M
IXING
B
OWL
Place the desired mixing bowl onto
the turntable so that the groove in the
bottom of the bowl fits into the correct
groove in the turntable.
Mixing bowls should NEVER be used in
a conventional oven, microwave oven,
on top of the range, or on any other
heated surface.
NOTE: If mixing bowls are scratched
or chipped, do not use mixer. Mixer
bowl should not be used to blend in
hot liquids.
Mixer-Release
Trigger
Latched Opening
Ball Bearing
Extension
Small
Bowl
Large
Bowl
Mixer
Head
Mixer-Release
Trigger
Metal
Pivot
Stand