Filter
Top Products
8. When processing is complete, turn the cover
to the right (clockwise), this will stop the food
processor (5).
9. Remove the processing blade from the bowl
before removing the processed food.
Note: The stainless steel processing blade is only
for use in the processing bowl, for in-bowl
chopping, mixing or pureeing functions; NEVER
in the continuous flow attachment.
Using continuous flow processing
1. Set up the motor base facing you on a dry,
level surface.
Note: The tallest side of the motor housing to
the rear.
2. Place the processing bowl over the drive shaft
and rotate the container until it drops down
evenly onto the base. Turn the processing
bowl anti-clockwise firmly until it ‘locks’ into
place (1).
3. Place the ejector disc into the processing bowl
by holding the shorter stem and placing the
disc onto the drive shaft (6).
For Slicing:
4a.Hold the slicing/shredding disc with the raised
slicing blade facing upwards. Place the
slicing/shredding disc onto the drive shaft,
sitting over the ejector disc (7).
For Shredding:
4b. Hold the slicing/shredding disc with the
series of raised small notches facing upwards.
Place the slicing/shredding disc onto the drive
shaft, sitting over the ejector disc (8).
Using your Sunbeam Oskar 400 (cont).
7
(5)
(7)
(8)
(6)
Ejector
disc
Drive
shaft
Slicing
blade
Shredding
blade