Filter
Top Products
8
Using your FoodSaver
®
VAC700
How to make a Bag from a FoodSaver
®
Roll
1. Place appliance on a flat, dry surface
and plug the supply cord into a standard
electrical outlet.
2. Open appliance lid and place roll into Roll
Storage Compartment. For best results,
insert roll with material flap down.
Note: Bags can be sealed with appliance lid
either opened or closed. See figure 1.
3. Lift up Bag Cutter Bar and place bag
material beneath the Cutter Bar.
See figure 2.
4. Pull out enough bag material to hold item
being vacuum packed, plus 7.5cm. Lower
the Cutter Bar and slide Bag Cutter across
the Cutter Bar. See figure 3.
5. Lift Bar, place bag over sealing strip, gently
lower bar, press Seal button. Once red light
goes off, lift bar and remove bag.
See figure 4.
6. You now have one sealed end.
See figure 5.
Figure 1
Figure 2
7.5cm
Figure 3
Figure 4
OPEN END
SEALED END
Figure 5