Filter
Top Products
Tandberg Data System Management
_____________________________________________________________
5-4 Tandberg Viking FS-1600 Series NAS Hardware User Manual
Notes
Further RAID configuration can be performed using web-based RAID manager after
the OS is recovered using a web-browser and point to the following URL:
http://<your NAS appliance IP address>:81
The default user name is “admin”. The default password is “0000”.
6. Exit from the BIOS by pressing F10 key and system will restarted.
For further detail on configuring RAID and Volume sets using the controller
BIOS as well as using the web-based RAID manager, see ARECA ARC-
1160/ARC-1261ML Serial-ATA RAID Controller User Manual.
5.2.2. Changing RAID Level and Capacity Size
The RAID BIOS and web-based RAID manager are also used to change the
RAID level as well as the capacity size of the configured volumes. After the
creation of the System and the Data Volume, further alteration to their RAID
level and capacity is allowed via these means.
1. Access either the RAID BIOS or the web-based RAID manager, see
details in section 5.2.1.
Notes
See the ARECA ARC-1160/ARC-1261ML Serial-ATA RAID Controller User Manual
for further details.
2. The ARC-1160/ARC-1261ML Serial-ATA RAID controller will
perform the configuration change once confirmed. Depending on the
extend of change the process may take a few minutes to several
hours to complete. The appliance must be rebooted for the change
to take effect.
5.3. System Recovery
The Image Restoration lets you restore the system image factory default
settings.
Notes
Using the Image Restoration utility removes all data on the System Volume. Make
sure that you back up important files before starting the restoration process. Image
restoration can only be performed after System Volume has been created.