Filter
Top Products
11
SURFACES CLEANING AGENTS INSTRUCTIONS
Porcelain Enamel Mild Cleaners or soap-filled steel Use a damp sponge or dampened soap pad,
(Cooktop, wool pads rinse and dry
Surface under cooktop)
Insert – Control panel Hot, soapy water or cleaner Use a clean, soapy, dampened cloth or paper towel,
cream remove soil and dry. Do not use abrasive products.
Cleaning the Appliance
Exterior Cleaning
Clean range after each use to prevent sticky
grease built-up and spills from cooking on. Wash with hot, soapy water and a clean cloth. Wipe with a soft cloth or paper towel.
Do not use abrasives, steel wool, cleaners containing ammonia, acids or commercial oven cleaners on any exterior parts of the
range, except the porcelain enamel cooktop. If a metal cleaner or polish is used on metal trim, be sure the label specifies that it is
safe for use on chrome and aluminium.
Steel/Aluminum Control Panel
Control knobs (some models)
If the control panel needs cleaning turn the control knobs to OFF “
”, then pull knobs straight off
the shafts.
Most cleaning of your steel/aluminum control panel can be done using a clean cloth with warm
soapy water or other mild household cleaners.
Sometimes, applying few drops of a recommended cooktop cleaning/polishing cream (with
silicone) will remove any remaining soil and will leave a protective coating which will keep your
range looking like new.
Cooktop cleaning/polishing cream can be purchased through authorized service centers or major
department stores.
Coil Surface Elements (some models)
Coil Elements and Drip Bowls
Coil elements clean themselves when they are turned on.
Coil elements and drip bowls are removable and allow to clean the drip bowls.
To remove a coil element, push against the front
edge and lift element up and out.
To clean by hand, wash the drip bowls in hot sudsy
water. For hard to remove spots, use a nylon
scrubber with soap. Rinse and dry while still warm.
Never immerse coil elements
in water.
Before cleaning any part of the range, make sure all heating
elements are turned to OFF “ ” and are cool.
Prior to cleaning the coil elements make
sure they are cold and that control knobs
are turned to OFF “
”.
Never leave covers on the
coil elements as they could be permanently
damaged if the coil is turned on by accident.