Filter
Top Products
Understanding the Venting Process:
• In this process, the hot steam from the dishwasher is being drawn into the drain pump through its
vacuum force and the mix condensation of water and air is being discharged through the discharge
hose from the back of the unit.
Checking Water Temperature:
• Your incoming water must be between at least 120 Degree F / 49 Degree C and most 150 Degree F /
66 Degree C but no more than 150 Degree F / 66 Degree C in order to have effective cleaning and
prevent damage to your dishware.
If you are not sure of what degree your hot water temperature is at:
1. 1. Simply open the hot water faucet and let it run for a minute and fill a glass.
2. 2. Take a thermometer and check the temperature of the water.
3. 3. If the temperature is below 120 Degree F / 49 Degree C, then you need toadjust water regulator
in order to maintain that temperature level.
Note: We recommend that you select hot water instead of cold water from the faucet to reduce the time
to heat up the water and to have the detergent properly dissolve in the water quickly in order to
clean the dishware effectively. Your unit is equipped with heater that will automatically increase
the water temperature quickly to remove grease and soil off the dishware and dissolve detergent
properly.
Overflowing Protection:
. • In the event the water flowing into the machine is not cut off as foreseen by the program and the
water level rises above the highest acceptable point, the security pressure switch automatically activates the
drainage pump which immediately empties the water.
. • This happens when the machine is operating (ON). When the machine is on "OFF" position, the
water supply to the dishwasher must be shut at the end of the program in order to isolate the machine from
the pressure in the network. This is especially necessary if you will be absent from your home.
13