Filter
Top Products
24
Models 340, 341, 342Troubleshooting Guide
PROBLEM PROBABLE CAUSE REMEDY PAGE
REF.
9. The guide bearing is
missing.
a. The guide bearing is stuck
in the drive shaft.
a. Remove the guide bearing
from the hole in the drive
shaft.
-- --
10. There is excessive
leakage from the door
spout.
a. There is improper or
inadequate lubrication on
the draw valve o-rings.
a. Use an approved food
grade lubricant (example:
Taylor Lube) and follow
the lubrication procedures.
11
b. The draw valve o-ring is
bad or missing.
b. Replace o-rings every
three months.
25
11 . The door will not go into
position easily.
a. The beater assembly is
incorrectly positioned.
a. The open end of the
beater assembly should
be in the 11 o’clock
position.
13