Filter
Top Products
the settings made. These settings include
the power levels, the timer of the heating
elements, as well as the Power and Heat-
Up functions.
After having disconnected the control
panel using the on/off sensor button
(1), you will have six seconds to turn on
the hob again. After doing so, to recover
the settings lost, touch the Stop sensor
button (6) before another six seconds
pass.
This function will only work if at least one
heating element is active, regardless of
the Lock function.
The activation of the Recovery Function
will be confirmed by a beep.
Heat-up function
(Automatic start of cooking)
This function will help you when cooking,
since it is not necessary to be there at the
same time. The touch control panel pre-
programmes the chosen heating element
to the maximum power level and then
lowers it to the desired power level, chosen
by you, after a certain amount of time. (See
table 1)
TURNING ON THE FAST HEAT-UP
FUNCTION
1 Use the corresponding indicator (3) to
activate the desired heating element.
2 Using the Slider cursor (2), slide your fin-
ger up to power level 9 and then touch
the sensor button corresponding to level
9 again. A flashing A will appear in the
indicator.
The power level decreases to the desired
continuous power level (for example, 6)
within the 15 seconds following the activa-
tion of the fast heat-up function by means
of the slider cursor (2). The indicator will
flash alternately between 6 and A.
Example:
You want to cook at power level 6 on an
induction element and you want to quickly
heat up the contents of the cookware at the
beginning.
Choose power 9, touch the slider cursor (2)
and an A will appear, then use the slide cur-
sor (2) to lower the power level to 6. The
system will keep the heating element at
power level 9 (maximum) for 120 seconds,
flashing alternately between 6 and A; after
that time, the system will automatically
lower the power level to 6.
MODIFYING THE POWER LEVEL
DURING THE FAST HEAT-UP
1 The chosen heating element must be
activated. The corresponding decimal
point must be on (16).
2 Change the power level using slider cur-
sor (2).
When increasing the power level using the
slider cursor (2), the system takes into
GB
24
Table 1
0
48
144
228
312
408
120
168
216
- - -
0
1
2
3
4
5
6
7
8
9
Level
selected
Duration of Heat-Up
(in seconds)