Thermador C302 Double Oven User Manual


 
C Oven Care and Use Manual
Do-It-Yourself Maintenance
Do-It-Yourself Maintenance
REPLACING THE OVEN LIGHT – LOWER OVEN ONLY
Replace bulb with a 12-Volt, 10-Watt Halogen
bulb only.
Before replacing bulbs, turn off oven circuit.
To replace Halogen Bulb:
1. Remove oven racks.
2. Slide the tip
of a table
knife blade
between
oven wall and
the center of
the side of
the protec-
tive glass lens
cover.
3. Support the
glass lens cover with two fingers along the
bottom edge to prevent the cover from falling
to the bottom of the oven.
4. Gently twist the knife blade to loosen the glass
lens cover.
5. Remove the glass lens cover.
WARNINGS:
To prevent electrical shock and or personal injury:
Before replacing the light bulb, be sure the
electric power is turned off at the circuit
breaker.
Do not operate the oven unless the light cover is
securely in position.
Halogen bulbs get HOT instantly when turned ON.
Be sure the oven and light bulb are cool.
Light Bulb
Lens Cover
Light
Socket
CAUTION: If the light cover is damaged or broken,
do not use the oven until a new cover is in place.
The oven lights are located, on the left and right side
walls of the oven. The lights have a removable lens
cover and a halogen light bulb. The ceramic light
socket housing is not removable by the user.
6. Remove the bulb by grasping and sliding the bulb
straight up until the two prongs have cleared the
ceramic holder.
7. Do not touch the glass of the new replacement
bulb with your fingers. It will cause the bulb to
fail when it first lights. Grasp the replacement
bulb with a clean paper towel or facial tissue
with the prongs facing down. Locate the two
prongs in the ceramic holder, gently poking until
the two prongs locate in the ceramic socket.
8. Press down to seat the bulb.
9. Snap the protective glass lens cover over the
bulb housing.
10. Turn on circuit breaker.
11. The upper oven light must be replaced by a
qualified service technician. See Page 36.
Page 33
The oven has been preset to a 12
hour clock format.
To Change the Time of Day Clock
to a 24-Hour Clock, follow these
steps:
1. Turn off both ovens.
2. Touch and hold the UPPER
, then touch the
CLOCK pad at the same time.
3. 12H appears in the Clock window; release
both pads.
4. Touch CLOCK and 24H replaces 12H. This
alternates when CLOCK is touched.
5. To complete the change, touch or
OFF.
UPPER
OFF
UPPER
OFF
CHANGING TO
THE
24-HOUR
CLOCK
FORMAT