Filter
Top Products
CONTROL KNOB — ALL STANDARD BURNERS
OFF
HI
LO
Glass
Models
ExtraLow™ CONTROL KNOB SETTINGS
OFF
LO
HI
XLO
THERMADOR
®
EXTRALOW™ BURNERS
(ModelsGGS/SGS)
The left front 9,100 BTU/HR burner
and left rear 11,000 BTU/HR burner
are designed to provide flame set-
tings which enable you to simmer,
poach, melt and hold cooked food at
a serving temperature, without
scorching or burning. This is accom-
plished by cycling the flame OFF and
ON for varying lengths of time.
HOW THEY WORK
• The BTU/HR usage on the 9,100
BTU/HR burner ranges from HI
(at 9,000) to XLO (at 300). The
BTU/HR usage on the 11,000
BTU/HR burner ranges from HI
(at 11,000) to XLO (at 365).
• There are an infinite number of
settings between HI and XLO; the
control knob can be set at any po-
sition.
• The burner flame will pulse ON
and OFF when the setting is at any
position between LO and XLO.
• The length of time the flame is ON
and OFF varies.
• With a setting just below LO, the
flame will be ON approximately
50 seconds and OFF 10 seconds of
each minute.
• With a setting at the XLO position,
the flame is ON approximately 10
seconds and OFF 50 seconds of
each minute.
FOR THE BEST RESULTS
• Temperature control will be more
accurate if a lid is used.
• Bring food to a rolling boil; stir
well to be sure all the food is boil-
ing; cover and reduce the heat to
just below LO.
• Check periodically to see if the
control knob should be turned to a
lower setting.
1
2
1
2
3
4
5
5
3
4
1. ExtraLow™ 300 to 9,100 BTU/
HR Burner and Control Knob
2. ExtraLow™ 365 to 11,000
BTU/HR Burner and Control
Knob
3. 950 to 6,500 BTU/HR Burner
and Control Knob (Models
GGSCV365 and GGS365)
4. 1300 to 9,100 BTU/HR Burner
and Control Knob
5. 1650 to 11,000 BTU/HR Burner
and Control Knob
Model GGS365
1
STANDARD BURNER CONTROL KNOB SETTINGS
Porcelain/Stainless
Models
Section Four: Using the Cooktop
COOKTOP OPERATION
SGS
Porcelain/
Stainless Models
GGS
Glass
Models
Both ExtraLow controls are push in to turn and have an infinite number of heat
settings, with no fixed positions. The ExtraLow settings are between XLO and
just after LO, at the detent, shown by the broken line.
CONTROL KNOB —
Thermador
®
ExtraLow™ BURNERS
All the controls are push in to turn and have an infinite number of heat settings,
with no fixed positions. Select the appropriate control knob and turn it
counterclockwise to the HI position (detent) until the burner lights. Adjust the
flame size. Turn off by turning the control clockwise to OFF.
Page 11