Filter
Top Products
Page 5
CLEANING INSTRUCTIONS
Be sure lights are cool
before cleaning the hood.
To Clean Filter/s
• It is recommended that the
filters be washed at least
once a month; they can be
washed by hand or in the
dishwasher.
• Drain water through holes
along filter edges and allow to
dry thoroughly before
replacing it.
To Clean Hood Surface
• For general care, wipe the
outside of the stainless steel,
white, black or glass hood
with sudsy water or
household cleaners such as
Fantastic® or Formula 409®,
rinse well and dry with clean
soft
cloth to avoid water
marks.
• Wipe and dry brushed
stainless steel in the same
direction as the grain.
• Do not use abrasive products.
• To remove finger prints and
give added shine use spray
cleaners such as Stainless
Steel Magic® and Shimmer®
FILTERS
The metal grease filters are
made of anodized aluminum and
are long lasting.
To Remove The Metal Grease
Filter/s
• Turn blower and lights off.
• Push each handle towards the
back and pull downwards Fig.
2.
To Replace The Metal Grease
Filter/s
• Reverse procedure.
LIGHTS
NOTE: Turn blower and lights
off. Make sure the lights are
cool. If new lights do not opera-
te verify lights are inserted
correctly before calling service.
Replace Lights For HNW
• Using a flat edge from a
screwdriver or equivalent tool
pry loose the lens cover as
shown in Figure 3.
• Remove the damaged light
and replace with a new 12
Volt, 20 Watt (maximum)
halogen light made for a G-4
base. Follow package
directions and do not touch
new light with bare hands.
• Reinstall the light cover.
Fig. 3
Fig. 2