Filter
Top Products
Page 4
Parts Included with your
Hood
• Hood Canopy Assembly with
Ventilator and Light Bulbs
Installed
• Care & Use /Installation
Instructions
• Registration Card.
• Filters, 1, 2, 3 or 4 depending on
model and size
• Plastic Transition with Back draft
dampers installed
• Screws and Drywall Anchors
• 2 Mounting Hooks
• Mounting Temple
• 2 Piece Duct Cover
• Rubber Tape (only for HSW and
HCSW model)
• 6" or 8" Starting Collar
• Contents Sheet
• 2 Rubber Gaskets
CONSIDERATIONS BEFORE INSTALLING HOOD
Parts Not Included with
your Hood
• Metal Transition if required
HGTR6 for HGSW model
HSTR6 for all other 400 CFM
hoods
HDTR8 for HDW models
• Duct Tape
• 1/2" Conduit
• Wire Nuts
• Plywood Wall Mounting Block
1. For the most efficient air flow
exhaust, use a straight run or as
few elbows as possible.
CAUTION: Vent unit to outside
of building, only.
2. Use flex ducting only to connect
rigid duct directly to transitions.
3. COLD WEATHER installations
should have an additional
backdraft damper installed to
minimize backward cold air flow
and a nonmetallic thermal break
to minimize conduction of outside
temperatures as part of the
ductwork. The damper should be
on the cold air side of the thermal
break. The break should be as
close as possible to where the
ducting enters the heated portion
of the house.
4. Hood installation height above
cooktop is the users preference.
The lower the hood above the
cooktop, the more efficient the
capturing of cooking odors,
grease and smoke. Thermador
recommends the hood be installed
30-36" above the countertop. The
lower height may be inconvenient
for tall people and large cooking
vessels. Check your ceiling height
and the hood height maximum
before you select your hood.