Filter
Top Products
Page 8
Alternate - reduced ceiling height
Installation for HDW and HTSW
and HGSW models:
The hood may be installed with only
the lower part of the duct cover to
reduce the overall height. This hood
height is signified by * in Table 1. For
the duct cover to slide down and
engage the top of the hood, the ceiling
bracket must be mounted 1/4" below
the ceiling. The resulting space on
top of the chimney can be filled with
a 1/4” thick piece of plywood cut to
the inside cross section of the chimney
cover and finished to match the
ceiling.
Copy the two mounting holes on the
sides of the upper cover to the lower
cover.
Rear discharge:
A 90° elbow may be installed
immediately above the hood. For
serviceability, a mounting similar to
the straight up discharge shown in
Fig. C should be used. In Table 1
dimension "T" signifies distance from
hood bottom to top of transition.