Filter
Top Products
English 13
Step 6: Backguard Installation
For island installations and other installations with over 12”
(305 mm) clearance, the included Flush Island Trim may be
used. A Low Back guard must be installed when there is
less than a 12" (305 mm) clearance between combustible
materials and back edge of cooktop. (See Figure 1 and
Figure 5.) Clearances from non-combustible materials are
not part of the ANSI Z21.1 scope and are not certified by
CSA. Clearances of less than 12” (305 mm) must be
approved by the local codes and/or by the local authority
having jurisdiction.
Attach the backguard before sliding the appliance into the
final installed position. Follow Steps A through E below:
a. Depending on model, remove the 2 or 3 stainless Torx
screws in the front face of the included Flush Island
Trim. Lift up to fully remove the Flush Island Trim (A,
Figure 12).
b. Slide the support brackets between the two rangetop
chassis back panels. Secure each bracket with 4 x 1½”
(38 mm) screws (B, Figure 12).
c. Slide backguard over the two brackets on the rear of
the rangetop. Fasten them together with 8 x 1½”
(38 mm) screws (C, Figure 12).
d. Fasten the front of the backguard to the rangetop with
2 or 3 x ½” (12.7 mm) screws (D, Figure 12).
e. Place the backguard cap on top and secure using 2 x
½” (12.7 mm) stainless screws (E, Figure 12).
Low Back and Flush Island Trim Model Numbers
Rangetop
Size
12” Low Back
(sold separately)
Flush Island Trim
30”
36”
48”
PA30GLBC
PA36GLBC
PA48GLBC
Included with rangetop
Included with rangetop
Included with rangetop
Figure 12: Low Back Attachment
b.) Install support
brackets with 8 x 1½”
(38 mm) screws
a.) Remove Flush
Island Trim
c.) Slide backguard
over support brackets
& secure with 8 x
1½” (38 mm) screws
d.) Secure front with
½” (12.7 mm)
stainless screws
e.) Fasten cap
with 2 x ½”
(12.7 mm) screws