Filter
Top Products
OVEN LIGHT BULB REPLACEMENT
Replace only with a 5-watt, halogen appliance light bulb. DO NOT USE
a standard household light bulb in any oven.
TO REPLACE THE LIGHT BULB:
1. Turn oven light switch to the off position. Let bulb and cover cool
completely.
2. Remove the light cover.
3. Remove the burned-out bulb. Replace it with a 5-watt halogen
appliance light bulb only. Don't touch bulb with greasy fingers.
Follow bulb manufacturer's instructions.
4. Replace cover. Turn circuit back on, if need be. (See Caution.)
INTERMITTENT OR CONSTANT IGNITER SPARKING
Intermittent or constant sparking of the sealed gas surface burners can result from a number of prevent-
able conditions. Eliminate these conditions as indicated in the chart.
SYMPTOM CAUSE REMEDY
Intermittent sparking • Ceramic igniter is wet or dirty. • Carefully dry or clean igniter.
• Burner ports are clogged. • Clean ports on flame spreader
with a wire, a needle or
straightened paper clip.
More than four clicks of • Improper fit of burner cap onto • Align burner cap properly
igniter before lighting burner base. on burner base.
Constant Sparking • Range is not properly grounded. • Refer to Installation Instructions.
Have a qualified electrician
ground the range properly.
• Electrical power supply is • Refer to Installation Instructions.
incorrectly polarized. Have a qualified electrician
ground the range properly.
DO-IT-YOURSELF MAINTENANCE
POWER FAILURE
In the event of a power failure, only the standard
burners can be lighted manually. It is necessary to
light each standard burner individually.
If the cooktop is being used when the power failure
occurs, turn all of the burner control knobs to the
OFF position. Then, the standard burners can be
lighted by holding a match at the ports and turning
the control knob to the HI position. Wait until the
flame is burning all the way around the burner cap
before adjusting the flame to the desired height.
The two ExtraLow
®
burners on the far left side,
cannot be used during a power failure. Be sure to
turn them OFF if a power failure occurs, as they will
not turn back on until both control knobs are turned
OFF and then turned back on again. See “What to
do if you Smell Gas”, inside front cover.
If you have low gas pressure, contact your gas
company.
CAUTION:
Before replacing the light
bulb, be certain the Oven
Light Switch is in the off po-
sition. Let bulb and cover
cool completely before
touching. If the light bulb
glass comes loose from the
base, turn the power to the
oven OFF at the circuit
breaker panel, before at-
tempting to remove the bulb
base from the socket.
!
Page 41
SECTION SIX: CARE AND MAINTENANCE