Filter
Top Products
28 29
CLEANINGCLEANING
Removing the catalytic liners
the centre of the oven.
Removing and replacing the catalytic fan baffle (where fitted)
CAUTION
The oven must be switched off before removing the fan
baffle, and the fan baffle must be replaced in accordance
with instructions.
the fan baffle.
to bottom tabs from the oven back.
CAUTION
NOTE: It is critical that the fan baffle is replaced after
cleaning, before the oven is operated again.
into their corresponding slots in the oven back.
appropriate holes.
must be flush with the back wall of the oven.
CATALYTIC LINERS
(WHERE FITTED)
Removing and replacing the oven light and side light (where fitted)
globe replacement.
This can be purchased from the Customer Care Centre.
glass and lever off. Replace globe and snap glass
cover back into position.
WARNING
Make sure the appliance is turned off before you remove
or replace parts, to avoid the possibility of electric shock.
Releasing the grill element
We have designed the upper element with a hanger clip
to help you reach your oven roof for cleaning.
Retaining wire models
The element will drop down freely.
Rotating latch models
Replacing the oven top light (POR883 model only)
WARNING
Turn the appliance off at the main switch to make sure
there is no power to the oven.
at the top of the oven.
removed from the oven.
between the two metal clips on the left hand side,
as shown in diagram.
driver in and moving it upwards, whilst holding the
glass cover with the other hand. (If not supported,
the glass cover can fall and break).
its holder.
directly touch the surface of the globe with your fingers,
right side of housing; push up opposite end of
glass cover until it snaps into position.
CLEANING YOUR APPLIANCE