Filter
Top Products
10
CLEAN-UP OF BAKE/BROIL BAKE PAN, BROIL INSERT AND RACK
1. Always unplug and allow to cool completely before cleaning or moving.
2. Remove bake pan and bake rack.
3. Clean with a mild or non-abrasive cleaner and a plastic scouring pad.
4. Rinse and dry thoroughly.
CLEAN-UP OF NON-STICK WALLS AND INTERIOR
1. Always unplug and allow to cool completely before cleaning or moving.
2. Remove bake pan and bake rack.
3. Clean interior after each use to avoid buildup.
4. Clean with a mild or non-abrasive cleaner and a plastic scouring pad. Do
not rub too hard as surface can be scratched.
5. Rinse and dry thoroughly before closing door.
CLEAN-UP OF OVEN DOOR AND EXTERIOR
The door can be removed for easier cleaning.To remove it, open fully and lift,
clearing the hinge pins. Do not put in dishwasher.To replace, slide the door over
the hinge pins, being sure to gently push door all the way down on pins to avoid
glass breakage.
1. Always unplug and allow to cool completely before cleaning or moving.
2. Clean with glass cleaner or mild detergent and damp cloth or plastic scouri n g
p a d . Do not use an abra s i ve cleaner or pad as they might mar the finish.
3. Rinse and dry thoroughly with a clean cloth. Allow to dry before closing
door.
TO REPLACE OVEN LIGHT
1. Unplug unit and allow oven to cool completely.
2. Remove screw from oven light bracket, holding onto bracket to prevent
glass from falling.
3. Remove bracket and glass.
4. Remove bulb by turning counter-clockwise.
5. Replace with new bulb, turning clockwise.
6. Replace glass and bracket, being sure the two tabs on the bracket are in
the slots provided for them on the oven wall.
7. Replace bracket screw.
NOTE: Use only a GE S-6 or equivalent 6-watt, 120 volt bulb. Do not operate
the oven without the oven lamp glass in place.
Any servicing requiring disassembly other than the above cleaning and bulb
replacement must be performed by an authorized service center