Filter
Top Products
5 6
HOW TO ASSEMBLE YOUR FARBERWARE
®
OPEN HEARTH
®
ROTISSERIE
1. Follow the Assembly Instructions, Steps 1 through 5 on page 4.
2. Insert the Spit Supports into Spit Support Receptacles on both
sides of the Support Base. Fit the long ends of the Spit Supports
into the Receptacles with the open slots pointed upward and
facing forward.
3. To assemble the Spit, screw together the Spit and Spit Handle in
a counter-clockwise (left) direction.
4. Slide a Holding Fork into the Spit with prongs facing the center.
Spear and slide the food to the center of the Spit so that it is
balanced. Slide the second Holding Fork onto the Spit. Pierce
food with prongs of the Holding Forks to secure. Check again
that the food is balanced on the Spit and tighten the screws on
both Holding Forks to hold food in place.
(See Rotisserie Chart.)
5. Insert pointed end of the Spit into the Motor.
6. Positioning the Motor on the opposite side from the attached
Cord Set, carefully slide the Motor and Spit with food into the
open slots on the Spit Supports so that the food is as close to
the Heating Element as possible without touching it. The Motor
will lock into place.
7. Plug the Motor into a 110-120 volt AC wall outlet to start the
Rotisserie. (Check the clearance — the food must not touch
the Heating Element — if touching, move the Spit to a
higher position.)
8. Finally, plug the Heating Element Cord Set into a 110-120 volt
AC outlet. When Rotisserie and Grill are in use, no other
appliance should be plugged into the same circuit.
9. Cook as desired. (See Rotisserie Chart.)
PLACE THE GRILL ON THE COUNTER SO THAT IT IS NOT
UNDERNEATH CABINETS OR OTHER STRUCTURES.
DO NOT USE ALUMINUM FOIL OR ANY OTHER MATERIAL
THAT WILL INTERFERE WITH THE FLOW OF AIR IN THE DRIP
TRAY OR ON THE BODY.
CARE AND CLEANING OF YOUR
FARBERWARE
®
OPEN HEARTH
®
SMOKELESS
INDOOR GRILL/ROTISSERIE
Before using for the first time, wash and dry the Grill Body, Drip
Tray, Grilling Rack, Spit, Forks and Spit Supports for Rotisserie.
When cooking has been completed, remove food from Grilling
Rack or unplug Motor to stop Spit from rotating, and remove food.
Remove plug of Cord Set from outlet. Allow the FARBERWARE
®
Open Hearth® Smokeless Indoor Grill/Rotisserie to cool
completely. When cool, separate parts. If necessary, wipe Cord Set
and Motor with a damp cloth. Dry completely and set aside. The
Heating Element is self-cleaning — DO NOT WASH!
All of the remaining parts can be washed in hot, sudsy water or
placed in the dishwasher.
DO NOT CLEAN PARTS OF THE
FARBERWARE
®
OPEN HEARTH
®
SMOKELESS INDOOR GRILL/ROTISSERIE WITH A METAL
SCOURING PAD OR AN ABRASIVE CLEANSER AS THE SURFACE
MAY SCRATCH.
Soaking parts in hot, sudsy water will make cleaning easier. If
necessary, use a plastic mesh pad and/or non-abrasive stainless
steel cleaner. Rinse parts thoroughly and dry completely.
ALL REPLACEMENT PARTS FOR THE FARBERWARE
®
OPEN HEARTH
®
SMOKELESS INDOOR GRILL/ROTISSERIE
SHOULD BE AUTHORIZED FARBERWARE
®
PARTS.