Filter
Top Products
17 –
T
T
O
O
N
N
I
I
N
N
O
O
L
L
A
A
M
M
B
B
O
O
R
R
G
G
H
H
I
I
N
N
I
I
E
E
P
P
S
S Use and maintenance manual – Rev.01 - 07/2006
socket. Turn on the wall socket.
3. Now turn on the coffee machine by pressing
in the on/off button which is located on
the right hand side of the casing above the
water button. The on/off button has a circle
with the numeral ‘1’ inside the circle. Both
red LEDs will light up. The LED light on the
right hand side indicates that the machine is
‘on’ and remains lit all the time that the
machine is on. The LED light on the left
hand side indicates that the machine is
warming up and has not reached operating
temperature. The LED on the left hand side
will go off when the boiler has warmed up.
This usually takes a few minutes.
4. Pull the gearlever on the right hand side
towards you as far as it will travel to lower
the pod holder assembly and the spout.
Remove any used pod from the pod holder.
Remove a fresh coffee pod from its wrapper
and place it carefully onto the pod holder
above the spout. Ensure that the pod is
located centrally on the holder.
5. Close the pod holder assemblying by
pushing the lever away from you until you
feel some resistance. You now need to lock
the pod assembly by pushing the lever
further away from you until it will go no
further. Please ensure that you have locked
the pod holder assembly before you make a
cup of coffee.
6. Place a coffee cup on the machine under the
spout. It is recommended that you pre-heat
the coffee cup.
7. When the red LED light on the left hand side
of the machine has gone out this indicates
that the machine is ready to make coffee.
8. Press the water button (picture of cup and
saucer on it) which is located below the
on/off button on the right hand side of the
casing. The machine will now make a cup of
coffee.
9. Press the water button once more to stop
the flow of coffee from the spout. PLEASE
NOTE the machine does NOT stop
automatically and you must operate the
water button when you have made a cup of