Filter
Top Products
7 –
T
T
O
O
N
N
I
I
N
N
O
O
L
L
A
A
M
M
B
B
O
O
R
R
G
G
H
H
I
I
N
N
I
I
E
E
P
P
S
S Use and maintenance manual – Rev.01 - 07/2006
1.3. DESCRIPTION OF CONTROLS
On/ Off button: Push the button to turn the
machine on. The red LED light next to the button
will come on to indicate that the machine is on.
This LED will remain illuminated at all times when
the machine is on. Push the button again to switch
the machine off.
Hot water/ Coffee making button: Push the
button to start making a cup of coffee or to release
hot water through the spout (when there is no
coffee pod in the machine). Push the button again
to turn off the water supply.
Steam button: Push the button to prepare the
machine to make steam (boiler temperature rises
to 125°C). Push the button again to return to
coffee making (boiler temperture reduces to 95°C).
You cannot make coffee whilst the steam button is
depressed as the water temperature will be too
high. It takes a couple of minutes for the boiler to
reach the correct temperatute for steam. It takes a
couple of minutes for the temperature to drop back
down after you turn the steam button off again.
Temperature Led Light:
This red LED light is
on the left hand side of the casing next to the
steam button.
1 Light on = Machine is in the process of
heating up and is not yet ready. The boiler
has not yet reached operating temperature.
2 Light off = Machine is ready to make coffee.
The boiler has reached operating
temperature.
Steam release knob:
Ensure that the steam
arm is over the drip tray and slowly rotate the knob
anticlockwise for a few seconds to discharge any
residual water from the steam arm. Once the water
has been discharged turn the steam off again by
rotating the steam knob clockwise.
PLEASE NOTE: Do not use the steam supply for
longer than about 1 minute at any one time (see Par 5.1).