Filter
Top Products
5
(718)388-5650 (800) 221-5032 except NY fax: (718)388-5860 townfood.com
OPTIONAL REAR CONNECTION KIT
RM-55 REAR CONNECTION KIT INSTALLATION INSTRUCTIONS
Before installing the connection kit, install the provided pressure regulator:
a. Locate gas supply for the rice cooker. Installation must comply with the National codes so there
should be a shut off valve on the gas supply line to the rice cooker.
b. Install the supplied pressure regulator after the gas supply valve. An arrow on the body of the
pressure regulator indicates the direction of the gas flow. The arrow must be pointing in the direction to
the rice cooker. The rice cooker will not operate if the regulator is improperly installed.
c. Install the 3/4” x 1/2” bushing supplied into the pressure regulator outlet.
d. Install the supply side of the quick disconnect hose (provided by others) to the regulator per the
manufacturer’s instructions.
With the pressure regulator and the hose installed, install the rear connection kit. Be sure to use
approved materials on the pipe threads to prevent gas leaks.
1. Install 3/8” x 1/2” galvanized coupling onto the rice cooker inlet while using a wrench to secure the
unit’s gas manifold.
2. Install 1/2” galvanized street elbow onto the coupling.
3. Install pipe nipple bracket with two (2) screws provided. Holes for the screws are provided.
4. Install 1/2” x 10” galvanized pipe nipple.
5. Install 3/4” pressure regulator. Connect one end to the pipe nipple and the other end to the Quick
Disconnect.
6. Install the Quick Disconnect hose nipple per the manufacturer’s instructions.
7. Check your installation for leaks with an approved leak detector.
When appropriate, light the rice cooker and check for proper operation.
RM-55N RC Kit for Natural Gas
RM-55P RC Kit for Propane Gas
This kit allows the rice cooker to be
connected from the rear; It is
optional and is not furnished with
the rice cooker unless ordered.
Each kit includes:
1-3/4” pressure regulator
1-3/4” x 1/2” bushing
1-3/8” x 1/2” galvanized coupling
1-1/2” galvanized street elbow
1-1/2” x 10” galvanized pipe nipple
1- pipe nipple bracket with two (2)
screws
If using this kit, use only one
pressure regulator.