Filter
Top Products
24
BEFORE CLEANING THE APPLIANCE,
ALWAYS ALLOW THE COOLING FAN TO
COOL THE APPLIANCE DOWN BEFORE
SWITCHING OFF AT THE ELECTRICITY
SUPPLY.
CLEANING MATERIALS
Before using any cleaning materials on your
appliance, check that they are suitable and that their
use is recommended by the manufacturer.
Cleaners that contain bleach should NOT be used as
they may dull the surface finishes. Harsh abrasives
should also be avoided.
CLEANING THE BRASS PLATED
HANDLES AND CONTROLS
(WHERE APPLICABLE)
It is strongly recommended that only hot soapy water
is used for cleaning the handles and controls. ANY
OTHER CLEANING MATERIALS WILL DULL THE
BRASS PLATED FINISH.
CLEANING THE OUTSIDE OF THE
APPLIANCE
DO NOT use abrasive cleaning materials or scourers
on the outside of the appliance as some of the
finishes are painted and damage may occur.
Regularly wipe over the control panel and oven doors
using a soft cloth well wrung out in warm water to
which a little liquid detergent has been added.
Any spillage on the stainless steel finish must be
wiped off immediately.
Stainless Steel cream cleaners are abrasive and
should be avoided as they may dull the surface
finish.
Do not attempt to remove any of the control
knobs from the appliance as this may
cause damage and is a safety hazard.
CLEANING THE OUTER AND INNER
DOOR GLASS PANELS
To prevent damaging or weakening the
door glass panels avoid the use of the
following:
· Household detergents and bleaches
· Impregnated pads unsuitable for non-
stick saucepans
· Brillo/Ajax pads or steel wool pads
· Chemical oven pads or aerosols
· Rust removers
· Bath/Sink stain removers
The outer grill and oven door glass panels are
removable for cleaning.
TO REMOVE THE OUTER GLASS
1. Open the grill or oven door slightly to gain access
to the two cross head screws on the top of the
oven door.
2. Loosen the two screws using a Pozidrive
screwdriver.
3. Hold the door glass securely in place with one
hand remove the screws and washers with the
other hand.
The screws and washers retain the trim on the top
of the grill door. Note the position of the trim on
the door.
4. Holding the door and glass with one hand, gently
pull towards you and slightly lift the door glass
with the other hand to disengage the panel from
the location point at the bottom of the door.
Gently release the door to close it.
5. Clean the outer and inner glass using hot soapy
water or Hob Brite. Should the inner face of the
outer door glass be heavily soiled it is
recommended that soapy water with a high
concentration of soap is used. To prevent
streaking a glass cleaning spray may be applied
and the glass polished with a soft cloth. Ensure
that all parts are thoroughly dry before attempting
to replace the outer door glass.
CARE AND CLEANING