Filter
Top Products
21
Installation
CAUTION!
If the machine is connected to new pipes or pipes which have not been used for a long time, you
should run the water for a few minutes before connecting the inlet hose.
Inlet hose
Connect the inlet hose to a water tap with an
external thread of 3/4”.
The inlet hose can be turned either to the left or the
right to suit the installation by means of the locknut.
The locknut must be correctly fitted to avoid water
leaks.
Drain hose
- Connect drain hose to the sink. Secure it with the
supplied hose clamp.
- Required height: 30 to 100 cm above bottom of
the dishwasher.
- If you use a drain hose extension the total length
should not be longer than 4 metres. Likewise the
internal diameter of the couplings used for
connections to the waste outlet must be no
smaller than the diameter of the hose provided.
WARNING!
Any electrical and/or plumbing work required to install this appliance should be carried out by a
qualified electrician and/or plumber or competent person.
WARNING!
The dishwasher must not be connected to
open water appliances or instantaneous water
heaters. This dishwasher must be fed with cold
water.
WARNING!
Only use, for connection to the water mains,
new hose-set; old hose-set must not be
reused.
Water connection
156998 37/0en 7-10-2006 12:20 Pagina 21