Filter
Top Products
9
Setting the water softener electronically (see table)
The dishwasher must
be switched off
Release the button. The
End light will flash. The
number of flashes
corresponds to current
level set.
The End light might
flash 5 times, for
example. The flashing is
repeated every 5
seconds.
To change the level,
press the start / cancel
button. Each time the
button is pressed the
level increases. (Level 1
follows level 10).
The End light indicates
the new setting.
To memorise the
operation, turn the
programme selector dial
to position off.
Press and hold the start / cancel button and turn
the programme selector dial clockwise till the first
programme. Keep the button pressed until the
programme selector light and the start / cancel light
start flashing.
The water softener is factory set at position 5.
156998 37/0en 7-10-2006 12:20 Pagina 9