True Manufacturing Company TFP-32-12M-D-2 Oven User Manual


  Open as PDF
of 16
 
55
True Food Service Equipment, Inc.
............ www.truemfg.com ............
INSTALLATION / OPERATION INSTRUCTIONS
A. Placepackingmaterialbehindcabinetasacushion.
WARNING:
Make sure all bins, bin support bars, and lid are
removed from unit before placing unit on its back.
Carefullylaytheunitonitsbacktoremoveskid.
When lifting unit remember to
leave the cabinet upright for 24 hours before
plugging into power source.
B. Removeskidbyunscrewingallbaserailanchor
brackets.Placeskidtotheside.
C. Carefullyliftcabinetupright.
LOCATING
Removing
skid from
bottom of
cabinet.
CUTTING BOARD
A. Removethumbscrewsfromcuttingboardbrackets.
(Seefigure1).
B. Removebracketsfrombothsidesoftheboard.
C. Carefullyliftcuttingboard.
Figure 1.
ANCHORING THE TFP HOOD COVER
TFP Hood Installation Instruction
A. ThisisTRUE’srecommendedprocedurefor
installingthelidtothehood.
Seetheillustration.
Assembly
1.Locatethelid,(packagedwithinthecardboard
containerontopoftheunit),andpositionunderthe
hood.
2.Placelidintofinalposition,(beneathhood),align
hoodhingepinwithanchorholeonlid.
3.Repeatprocedureforotherendofhood.
TSSU Hood Installation Instruction
ecommended
equired
the sandwich salad hood cover to the hood.
See callout #1 on the illustration.
, (packaged within
the cardboard container on top of the salad
position
thumb
the factory
slotted thumb screw. See diagram of slotted
into
hood
cover
humb
4. Repeat procedure for both ends of hood.
Anchoring the TSSU
Anchoring the TSSU
Hood Cover
Hood Cover
®
LID
HINGE PIN
HOOD
 previous next