True Manufacturing Company TH-23 Food Warmer User Manual


 
............ www.truemfg.com ............
True Food Service Equipment, Inc.
3
3
SAFETY INFORMATION
The power cord of this appliance is equipped
with a 3-prong (grounding) plug which mates
with a standard 3-prong (grounding) wall outlet to
minimize the possibility of electric shock hazard
from this appliance.
Have the wall outlet and circuit checked by a
qualified electrician to make sure the outlet is
properly grounded.
If the outlet is a standard 2-prong outlet, it is your
personal responsibility and obligation to have it
replaced with the properly grounded 3-prong wall
outlet.
The heated cabinet should always be plugged into
it’s own individual electrical circuit, which has a
voltage rating that matches the rating plate.
This provides the best performance and also
prevents overloading building wiring circuits which
could cause a fire hazard from overheated wires.
Never unplug your cabinet by pulling on the power
cord. Always grip plug firmly and pull straight out
from the outlet.
Repair or replace immediately all power cords that
have become frayed or otherwise damaged. Do not
use a cord that shows cracks or abrasion damage
along its length or at either end.
When removing the cabinet away from the wall, be
careful not to roll over or damage the power cord.
HOW TO CONNECT ELECTRICITY
Do not, under any circumstances, cut or remove the third (ground) prong from the power cord.
For personal safety, this appliance must be properly grounded.
WARNING!
USE OF EXTENSION CORDS / ADAPTER PLUGS
Do not use adapter plugs or extension leads as these can cause safety issues and early failure of electrical components.
The use of adapters and extension cords will invalidate your warranty. NEVER USE AN EXTENSION CORD! NEVER USE AN
ADAPTER PLUG!
WARNING
Power supply cord ground should not be removed!
NOTE
To reference wiring diagram - Remove lower rear grill.
Wiring diagram is positioned on the inside cabinet wall.
NEMA plugs
TRUE uses these types of
plugs. If you do not have the
right outlet have a certi ed
electrician install the correct
power source.