Filter
Top Products
TLM, TLF, TLD
Page 32 April, 2007
Anti-Sweat Heater Wire Deflector
Kit Replacement (TLD Only)
All TLD models have anti-sweat heaters
under each lower rear door frame. Use the
following instructions to replace an anti-sweat
heater wire deflector kit.
WARNING
Shut off or disconnect power supply to
case before replacing any part of the
anti-sweat heater wire deflector kit.
Electrical power from wire ends could
damage other components and/or cause
personal injury or death.
1. Remove product from case.
2. Remove rear doors from door frame that
has defective anti-sweat wire. (See page
25 in this manual.)
3. Remove screws and door frame from
rear of case.
4. Drill out three rivets (1) securing the
anti-sweat heater wire deflector kit (2) to
the bottom of the door opening (3).
5. Unplug or cut wires to anti-sweat heater
wire (4) and remove defective deflector
kit (2) from case.
6. Install new anti-sweat heater wire defelctor
kit (2) in reverse order making sure not to
pinch the anti-sweat wires (4) under the
deflector plate.
7. After doors have been reinstalled, recon-
nect power to case. Replace product in
case after operating temperature has
been established in the case.