Filter
Top Products
18 1115R, 1175R, 29R, 1175BEV
12. Fasten upper hinge to unit (three screws)
(Figure 29)
.
Partially tighten screws.
13. Adjust door to assure proper seal. Tighten upper and
lower hinge screws securely.
14. Replace three plastic plugs removed in Step 10 into
holes on top of unit. Replace screws in holes in bottom
of unit on opposite side.
15. Replace the grille and grille cap. Be sure to place grille
cap on opposite side of unit from where it was
originally.
Black or White Model 1175R
To reverse the door, perform the following:
1. Remove the grille (two screws).
Figure 30
2. Remove top hinge from cabinet (four screws)
(Figure
30)
. Hold door to keep it from falling.
3. Lift the door off the bottom hinge.
Figure 31
4. Remove four plastic plugs
(Figure 31)
in hinge holes,
top of cabinet, opposite side. Be careful not to scratch
cabinet.
Figure 32
5. Remove pivot screw from top hinge, invert screw and
reinstall pivot screw in top hinge
(Figure 32)
. Do not
install hinge on cabinet at this time.
Figure 33
6. Remove bottom hinge from cabinet (four screws) and
screws on opposite side of cabinet
(Figure 33)
.
7. Remove pivot screw from bottom hinge, invert screw
and reinstall pivot screw in hinge
(Figure 32)
.
Figure 34
8. Install bottom hinge on cabinet, opposite side, aligning
flat edge of hinge with outer edge of unit
(Figure 34)
.
Partially tighten screws.
ULIN_0104_A
ULIN_0105_A
Plastic
Plug Hole
Plastic
Plug Hole
Hinge
Screw
Right Side
Door Swing
Right Side
Hinge
Invert
Screw
Invert
Hinge
Left Side
Door Swing
ULIN_0106_A
ULIN_0107_
A
ULIN_0160_A
ULIN_016357_30087.fm Page 18 Tuesday, March 14, 2006 2:36 PM