Filter
Top Products
8 2175DWRWC
Figure 5
To display actual temperature of each drawer:
Press the UP and DOWN icon touch sensors (Figure 5)
simultaneously for three seconds. The display indicates
the actual temperature. After approximately 10 seconds,
the set-point temperature will display.
To adjust the temperature set-point:
• Touch and hold either the UP or DOWN icon for that
drawer for three seconds. When the LED displays “SP,”
lift your finger from the control panel and the
corresponding LED will begin to flash the set-point.
• Touch the UP or DOWN icon until the desired set-point
displays. Wait 10 seconds for the new set-point to be
saved.
Wait 24 hours for the temperature to stabilize before
checking the actual temperature again. Each wine
compartment can be set to 40-60°F.
Checking Product Temperature
Figure 6
To check the actual product temperature in your unit,
insert an accurate thermometer into a plastic (non-
breakable) bottle that is partially filled with water.
Tighten the bottle cap securely (Figure 6).
Place the bottle in the desired area for 24 hours. Refrain
from opening the unit during the testing period. After 24
hours, check the temperature of the water. If required,
adjust the temperature control in a small increment (See
ADJUSTING TEMPERATURE).
Factors which affect the internal temperatures of the
cabinet include:
• Temperature setting.
• Ambient temperature where installed.
• Number of times and length of time the door is
opened and closed.
• Installation in direct sunlight or near a heat source.
Normal Operating Sounds
All models incorporate rigid foam insulated cabinets to
provide high thermal efficiency and maximum sound
reduction for its internal working components. In spite of
this technology, your model may make sounds that are
unfamiliar.
Normal operating sounds may be more noticeable
because of the unit’s environment. Hard surfaces such as
cabinets, wood/vinyl/tiled floors and paneled walls have a
tendency to reflect normal appliance operating noises.
Common refrigeration components, and a brief
description of the normal operating sounds they make,
are listed below. NOTE: Your product may not contain all
of the components listed.
• Compressor: The compressor makes a hum or pulsing
sound that may be heard when it operates.
• Evaporator: Refrigerant flowing through an evaporator
may sound like boiling liquid.
• Condenser Fan: Air moving through a condenser may be
heard.
• Automatic Defrost/Drain Pan: Water may be heard
dripping or running into the drain pan when the unit is in
the defrost cycle.
ULIN_0241_A
ULIN_0093_A