Filter
Top Products
16 2275DWRWS, 2275DWRWOL
Side-to-Side Adjustment
Figure 17
See Figure 17. The drawer will need a Side-to-Side
Adjustment if, when viewed from the top, the drawer
front is not square with the sides of the cabinet. This is
caused by one of the slides being mounted too far
forward on the unit’s liner.
Minor Adjustment:
NOTE: The mounting holes on the slide are slightly
larger than the screws’ diameter.
Figure 18
1. Loosen the slide’s mounting screws.
2. Push the slide backward.
3. Retighten the screws. See
Figure 18
.
Severe Adjustment:
NOTE: The slides have extra mounting holes that
may be used.
Figure 19
1. Remove the slide’s mounting screws.
2. Reposition the slide so it is the same distance from the
front of the liner as the other slide. Measure to confirm.
3. Mark new drilling holes using different sets of
mounting holes on the slide. See
Figure 19
.
NOTE: Front location holes are shown.
Corresponding rear holes will also need to be
marked.
4. Drill all the new holes with a #30 drill bit.
5. Remount the slide.
Front-to-Back Adjustment
Figure 20
See Figure 20. The drawer will need a Front-to-Back
Adjustment if, when viewed from the side, the drawer
front is cocked forward or back. This is caused by the front
slide mountings not being level with the rear slide
mountings.
Top View of Unit
Not Aligned Side-to-Side
ULIN_0001c_A
Push Slide
Backward
Loosen
Mounting Screws
ULIN_0001d_A
Mark and Drill New
Mounting Holes
Push Slide
Backward
ULIN_0001e_A
Not Aligned Front-to-Back
Side View of Unit
ULIN_0001f_A
ULIN_016357_30179.fm Page 16 Thursday, February 1, 2007 1:24 PM