Filter
Top Products
16
®
CAST IRON STOVE AND BURNER SYSTEM
106707
For more information, visit www.desatech.com
SBVRBN AND SBVRBP
INSTALLING OPTIONAL
WIRELESS HAND-HELD
REMOTE CONTROL
ACCESSORIES - GHRC AND
GHRCTA SERIES
Installing Remote Receiver
1. Open bottom door on stove body.
2. Disconnect wires from THTP and TH
on control valve that lead to the switch
(see Figure 34, page 15). Discard
switch plate, screws, and nuts.
3. Install battery into receiver battery clip
and connect to terminals (see Figure 37).
4. Place receiver into valve bracket and
align holes (see Figure 38).
5. Use push-in fasteners included with
receiver to secure to bracket.
6. Connect the wires from the receiver to
the valve at TH and THTP (see Figure
34, page 15).
Figure 37 - Installing Battery in Receiver
9-Volt Battery
Receiver
Battery
Clip
Terminal
Wires
L
O
H
I
P
I
L
O
T
OFF
ON
Figure 38 - Installing Remote Receiver
WARNING: Do not connect
this thermostat to a power
source. Electrical shock and/or
fire hazard will occur.
3. Connect one terminal of the wire for
the wall thermostat to the THTP termi-
nal on the valve. Connect remaining
wire terminal to the TH terminal on the
valve. Make sure that the wire termi-
nals are in the positions on the unit as
pictured in Figure 34, page 15. If wires
are not connected as shown the ther-
mostat will not work.
4. Route the wire to a convenient loca-
tion to mount your thermostat (no out-
side wall).
IMPORTANT:
The wire
must not exceed 25 feet in length.
The thermostat should be mounted 54"
above the floor in a location where
there is good air circulation. Avoid
heat sources such as lamps, direct sun-
light, fireplace, or heat and air condi-
tioning ducts.
5. Gently remove the cover of the ther-
mostat from the base. Grasp the sides
of the cover firmly and pull to separate
from the base.
6. Feed the electrical wires through the
rectangular slots (from the back) on
each side of the base (see Figure 35).
Figure 35 - Back View of Thermostat Base
Feed wires through
rectangular slots
Figure 36 - Thermostat Base Terminal
“W” and “R”
W
R
Terminal “W”
Terminal “R”
CAST IRON STOVE
AND B-VENT
BURNER SYSTEM
INSTALLATION
Continued
7. Connect one bare wire end to each ter-
minal (“W” and “R”) of the thermostat
base (see Figure 36).
8. Install the base to the wall with screws
provided with thermostat.
9. Move the temperature adjustment back
and forth to insure the bi-metal is free
from restrictions.
10. Replace the cover onto the base. (Upon
installation, the thermostat must be al-
lowed to stabilize at room temperature
for a minimum of 30 minutes for proper
operation.)
11. Set the temperature adjustment to the
desired setting. This thermostat has been
electronically calibrated at the factory.
No adjustment or leveling is necessary.