Filter
Top Products
Belt adjustments
17
NEVER move the base for motor (R)(in the oblong
holes) , this is a factory setting and is NOT used to
tighten the belts.If the entire unit is to be
exchanged, reference the below table.
Models W30-W40(P) Distance (B) 11 1/2 inches
Models W60-W150 Distance (B) 12 1/4 inches
1. Start by tightening the V-belts (C).
1.A) Loosen the bolts (D) and the jam nut (E).
1.B) Tighten the bolt (F) until the V-belts are tight,
........tighten the the 2 bolts (D).
...C) Back bolt (F) out away from arm. DO NOT
........LEAVE AGAINST ARM.
2. If the main vari belt (A) appears loose when the
....unit is running.
...A) Remove nut (J) and washers (H).
...B) Pry upper spring fork assembly (N)
off of shaft.
...C) Remove 1 or 2 washers from (G).
...D) Reinstall spring fork assembly (N) , washers
.......(H) and nut. (J). DO NOT TIGHTEN NUT.
...E) Start the mixer and tighten nut (J) until snug.
3. Now turn to Page 20 and follow the instructions
...“Adjustment of low (min) and high (max) speed
..
....microswitches”.