Filter
Top Products
ENGLISH
Use & Care Manual
12
If a hot surface light is ON use caution when working
around the cooktop as it is still hot.
Fast Boil (Booster) function
Once a heating element has been selected, touch the
[FAST BOIL] key to enable/disable this function, before
or after setting the power level.
A beep sounds and the heater display shows the
selected power level and a “P” alternatively. The
“Peacock Tail” shows the selected power level.
The heater works at full power (level 9, always on) for
10 minutes. After these 10 minutes the heater returns
to the selected power level.
This option is available for all the cooking zones, both
standard, both special ones (multiple zones or bridge).
Key Lock function
The key lock function is activated or deactivated holding
the [LOCK] key for 2 seconds. The lock indication turns
on, the keyboard is locked. Of course, the [LOCK] key
itself is always enabled.
The keys are automatically locked at start-up.
The locking function can be activated regardless of the
heaters condition (working or not). The key lock function
locks all the keys but the [OFF] ones. Also the general
[ON/OFF] key remains active for the off function.
Setting the timer
It works as a minute minder and it doesn’t stop any
heating element.
The timer is available in some models only. It can be set
independently from the heating element, even if there
aren’t any working zones. If the cooktop is not working,
touch rst the main [ON/OFF] key to enter stand-by
mode, with all displays showing “0”.
1
2
3
Figure. 10
Touch [T-] or [T+] keys to set the timer: the initial value
starts from “00” or “45” respectively on the timer display
(ref.1). Hold the key in order to fasten the increase/
decrease speed. The maximum value is “99”.
The timer led (ref.2) indicates whether the timer is
running.
The dot in the lower right corner of the display (ref.3) is
ashing when the timer has been selected in order to
change its value. After 5 seconds since the last touch
the new value is accepted and the dot disappears.
A beep conrms that the new value was accepted
correctly.
To cancel the timer, hold [T-] key until the value decrease
to “00” or touch both [T-] and [T+] simultaneously in
order to reset the value to “00” rapidly.
In some models the timer can be set in relation with a
cooking zone:
• Select the cooking zone you want to time.
• Touch [T-] or [T+], the timer led related to the zone
starts ashing.
• Set the timer value.
• The timer led gets steady, the value is accepted and
the countdown begins.
If more than one timer is set, the display shows the
lowest value, the one that will expire rst. The timer led
(ref.4) related to the zone which the displayed value is
referring to, is ashing. If the displayed value refers to
the independent timer, the timer led (ref.2) ashes.
4
Figure. 11
To check the remaining time for any one of the timed
zone, touch the [ON] key related to the zone: the
corresponding timer led will begin to ash and the value
on the timer display will switch for some seconds to the
new value. After a time-out, it will switch back to the
shortest one.
To check the independent timer value when it’s not
displayed with the highest priority, touch [T-] or [T+] when
no zones are selected. The timer led (ref.4) ashes and
the displayed value switches to the independent timer.