Filter
Top Products
IMPORTANT
3
– Please Read and FollowTable of Contents
Warnings & Important Information _____________________________________________________3
Dimensions & Cutout Dimensions _____________________________________________________6
Specifications _______________________________________________________________________7
Custom Door Panel Specifications _____________________________________________________8
Custom Door Panel Installation Option_________________________________________________9
General Information ________________________________________________________________11
Site Preparation_________________________________________________________________11
Water Supply___________________________________________________________________11
Drain __________________________________________________________________________11
Electrical Connections_______________________________________________________________12
Hardwire Conduit Option (201 & 301 Models) ______________________________________13
Hardwire Conduit Option (451 Models) ____________________________________________13
Trim Installation Options (451 Models)_____________________________________________16
Counter Balance Spring Adjustment (If Necessary) __________________________________17
Installation_________________________________________________________________________18
Performance Checklist ______________________________________________________________22
Testing for Leaks________________________________________________________________22
Final Preparation________________________________________________________________22
Service & Registration_______________________________________________________________23
2
Site Preparation
It is recommended that a thorough site inspection be
conducted PRIOR to unpacking and moving this appliance.
WARNING
Make sure that incoming voltage is the
same as unit rating. An electric rating
plate specifying voltage, hertz, and amps
is attached to the product. Wiring the
dishwasher with more voltage than it is
rated for may cause severe damage. To
reduce the risk of fire, electric shock, or
injury to persons, installation work and
electrical wiring must be done by qualified
technician in accordance with all
applicable codes and standards, including
fire-rated conditions.
WARNING
The dishwasher door may not stay open
by itself until the door panel is installed.
Be aware of this when fastening the
dishwasher to the cabinet.
WARNING
Plumbing connections must comply with
applicable sanitary, safety and plumbing
codes.
WARNING
Electrical power must be turned off at
circuit breaker or fuse box before making
electrical connections. Disconnect the
electrical power supply and place a tag at
the disconnect switch indicating that you
are working on the circuit.
• Before beginning–please read these
instructions completely and carefully.
• DO NOT remove permanently affixed
labels, warnings, or rating plates from the
dishwasher. This may void warranty or
create an unsafe product.
• Please observe all national and local
codes.
• Please ensure that this product is properly
grounded.
• The installer should leave these
instructions with the consumer who should
retain for local inspector’s use and for
future reference.
• The dishwasher has a factory installed
backflow preventer. Do not add an
additional check valve.
• Failure to provide a 20” above floor level
(50.8 cm) high loop may result in improper
operation of the dishwasher.
• Remove pallet screws from base. Damage
could occur to dishwasher if screws are not
removed.